Bounty Hunter Time Ranger Manual do Proprietário descarregar pdf (Página 14)

Detector Touch Pads

POWER ON/OFF is used to turn the detector on.

ALL METAL / SMART TRAC is used to select the All

Metal Pinpoint mode of operation, to retune (reset) the

All Metal Pinpoint mode if it has drifted; and, if it is

held down for more than two seconds, to perform the

Smart Trac computerized ground balancing maneuver.

SNIFF is used to enable the SNIFF mode of operation.

BLANKER is used to enable the unit’s BLANKER

feature.

DISC TARGET

This button selects the programmable-

target Discrimination mode. When already in that mode, if

you tap the button, it activates the Accept and Reject

buttons to allow targets to be programmed to be either

accepted or rejected. When you’re done programming

targets, tap the DISC/TARGET button again to drop back

into Discrimination mode ready to resume searching.

PROGRAM SELECT is used to select one of four predefined

search programs. The first three are discrimination

programs and the fourth is Self-Tuning all metal mode.

ACCEPT and REJECT are used for Target Programming

in the Discrimination mode.

Touch pads

The detector control panel includes several touch pads as shown

and described in the following table. These touch pads are used to

set detector operation.

SNIFF

ALL METAL

SMART

TRAC

PROGRAM

SELECT

DISC

TARGET

POWER

ON/OFF

BLANKER

POWER

ON/OFF

ALL METAL

SMART

TRAC

BLANKER

DISC

TARGET

PROGRAM

SELECT

SNIFF

HIGH (+) and LOW (-) are used to increase or decrease

the detector's sensitivity.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Comentários a estes Manuais

Sem comentários

Bounty Hunter Time Ranger Manual do Proprietário Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Bounty Hunter Time Ranger